Experimental and Numerical Analysis in Carbon Fiber Composite Leaf Spring
Keywords:
CERO, leaf spring, FEA, carbon fiberAbstract
Now-a-days automobile manufacturers around the world is concentrating on weight reduction in the vehicles. Around 10-20% of the mass of the automobile was reduced by reducing the mass of the spring leaf. The carbon fiber leaf spring is fabricated and analyzed for reducing the weight. It was found that the new carbon fiber spring has good load carrying capacity. In addition, it has excellent stiffness. Moreover, it stores high strain energy. It has great strength to mass ratio. The solid model of carbon fiber leaf spring was made through CREO and analysis was executed through Ansys software.
References
Venkatesh, S., Shaik Dawood, A.K., Mohamed Nazirudeen, S.S., & Karthikeyan, R. (2012). Development of porous aluminium foam for making commercial vehicle leaf spring. Engineering Science and Technology: An International Journal, 2(4), 51-59.
Karlus, E.N., Himte, L.R., & Rathore, R.K. (2014). Optimization of mono parabolic leaf spring. International Journal of Advances in Engineering & Technology, 7(1), 283-291.
Saini, P., Goel, A., & Kumar, D. (2013). Design and analysis of composite leaf spring for light vehicles. International Journal of Innovative Research in Science, Engineering and Technology, 2(5), 1-10.
Shankar, S.S., & Vijayarangan,S. (2006). Mono composite leaf spring for light weight vehicle –design, end joint analysis and testing. Materials Science, 12(3), 220-225.
Rajendran, I., & Vijayarangan, S. (2001). Optimal design of composite leaf spring using genetic algorithm. Computers and Structures, 79(11), 1121-1129.
Rai, V., & Saxena, G. (2013). Development of a composite leaf spring for a light commercial vehicle. International Journal of Engineering Research and Application, 3(5), 110-114.
Sharma, A., Bergaley, A., & Bhatia, S.S. (2014). Design and analysis of composite leaf spring – a review. International Journal of Engineering Trends and Technology, 9(3), 124-128.
Hargude, N.V., Patil, N.D., & Awate, P.P. (2014). Review of composite material mono leaf spring. International Journal of Emerging Technology and Advanced Engineering, 4(5), 880- 882.
Pozhilarasu, V., & Pillai, T.P. (2013). Performance analysis of steel leaf spring with composite leaf spring and fabrication of composite leaf spring. International Journal of Engineering Research and Science & Technology, 2(3), 102-109
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 Arun Prabhu, K. Arunprasath, S. Jayaprakash, R. Madhubalakrishnan
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain the copyright of their manuscripts, and all Open Access articles are disseminated under the terms of the Creative Commons Attribution License 4.0 (CC-BY), which licenses unrestricted use, distribution, and reproduction in any medium, provided that the original work is appropriately cited. The use of general descriptive names, trade names, trademarks, and so forth in this publication, even if not specifically identified, does not imply that these names are not protected by the relevant laws and regulations.